Skip to content
Same-day and next-day appointments in most areas.
Specialized Fisher & Paykel repair service. Experienced technicians, genuine parts, service across major U.S. metro areas.
Error Code

Fisher & Paykel Washer Code 43: OOB Switch Fault

Error code 43
Appliance Washer
Quick answer

Code 43 points at the out-of-balance switch, either stuck on or unplugged. The manual starts with mechanical checks and ends with the controller.

Model compatibility: Fisher & Paykel reuses codes across series and model years, so 43 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.

Plain language

What this code means

The out-of-balance switch signal indicates the switch is permanently on or that its harness is disconnected.

A Smartdrive washer learns about a lopsided load through its OOB switch. Code 43, which Phases 1 to 6 all list, means the return signal says the switch is permanently on, or the harness leading to it is disconnected.

At a glance

Code 43
What it means The out-of-balance switch signal indicates the switch is permanently on or that its harness is disconnected.
What you can check Check that the washer is sitting level on its feet. Anything beyond that, including the switch, spring and wiring, is for a technician with the washer unplugged.
When to call a technician Book a service visit if the code stays. Mention any corrosion you noticed, since a corroded switch means replacing the switch and harness.

Stage one: mechanical

  • Can the switch move without restriction?
  • Do any harnesses get in the way of its travel?
  • Does it behave properly when activated? If suspect, replace it.
  • Corroded micro switch: change the switch and the harness, then install a condensation kit in the console area when the top deck lacks one.
  • The level of the machine, and the bias spring.

Stage two: wiring

The harness to the switch is expected to be correctly connected, with terminals in the normally closed position. If the terminals show corrosion, the harness is replaced.

Stage three: controller

When the steps above are done, the manual replaces the Motor Controller module (the Display Module on Phase 1).

Which parts are a user job

Check Who
Washer sitting level on its feet Visible from outside, so the owner can confirm it
Switch, spring, console, harness Technician, with the washer unplugged

Related sensor codes

Code 242 records a Phase 6 out-of-balance hit above the maximum for 5 seconds. Code 234 is the Phase 6 lid lock open circuit, and for it the Series 11 section ties the lid lock wiring to the OOB switch harness.

Washer repair in our metro areas

For washer repair in the Miami, New York, Houston, Los Angeles and San Diego areas, dial (844) 659-2290. Tell the scheduler whether there was any corrosion.

Source: Fisher & Paykel Smartdrive washer service manual 517766 (March 2003), section 19, Detailed Fault Codes

Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.

Code still active?

Have this Fisher & Paykel alert verified on site

Repeating fault codes usually need platform-specific testing. We confirm the cause and price the fix before work begins.

References

Sources & references

Code still active?

Have this Fisher & Paykel alert verified on site

Repeating fault codes usually need platform-specific testing. We confirm the cause and price the fix before work begins.

Book a repair

Tell us what’s wrong — we’ll take it from there

Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.

Hours Mon–Sat: 8:00 AM – 7:00 PM
Service area Serving Miami, New York, Houston, Los Angeles and San Diego metro areas.
Response time Same-day and next-day appointments in most areas.
Call Book diagnosis