Error 34 is the Phase 1 Smartdrive brake resistor fault: the motor braking circuit is not working properly.
Model compatibility: Fisher & Paykel reuses codes across series and model years, so 34 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
What this code means
Phase 1 Smartdrive washers: the motor braking circuit is faulty.
Phase 1 of the Smartdrive fault list contains 34, titled Brake Resistor Fault. The manual says in one sentence that the circuit controlling the motor’s braking is faulty.
At a glance
| Code | 34 |
|---|---|
| What it means | Phase 1 Smartdrive washers: the motor braking circuit is faulty. |
| What you can check | Write down the exact code and the model, and the Smartdrive phase if you know it. |
| When to call a technician | A technician must swap electronic modules to fix this. Do not buy a replacement part before the visit. |
What the manual has replaced, and when
| Rank | Part | Action |
|---|---|---|
| Primary | Motor Controller | Replace it |
| Secondary | Display Module | Replace it; if the fault clears, put the original Motor Controller back |
Plain reading
An electronic Motor Controller operates the wash motor in these washers, and slowing the basket falls to it. Code 34 reports that its braking side is at fault. No cause is given, whether a worn part or wiring, and there is nothing a user can check. Both listed actions are module swaps, bench work for a technician.
If the Display Module cures the fault, the old controller goes back in. Diagnosis can therefore take two steps, and buying a replacement controller before then would be premature.
Close relatives on Phase 1
- Code 35 is a false-signal fault going from the Display Module to the controller.
- Code 33 is the valve fault.
Models and cautions
The fault booklet lists seven Phase 1 models, which are GW070, GW060 and GW050 together with GW650, GW500, GW600 and GW700. Washers of a later phase do not follow this, because the entry exists for Phase 1 and nowhere else. According to the booklet, the displayed code is the last fault recorded and must be confirmed each time.
Repair for Smartdrive washers in the Miami, New York, Houston, Los Angeles and San Diego metro areas
If a Fisher & Paykel washer shows 34, call (844) 659-2290. The model and the exact code are the helpful details, and the Smartdrive phase too if you know it.
Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.
Sources & references
Tell us what’s wrong — we’ll take it from there
Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.