Skip to content
Same-day and next-day appointments in most areas.
Specialized Fisher & Paykel repair service. Experienced technicians, genuine parts, service across major U.S. metro areas.
Error Code

Fisher & Paykel Washer Error 35: MC Reset

Error code 35
Appliance Washer
Quick answer

35 is a Phase 1 Smartdrive fault in which the Display Module sent a false signal to the Motor Controller.

Model compatibility: Fisher & Paykel reuses codes across series and model years, so 35 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.

Plain language

What this code means

Phase 1 Smartdrive washers: the Display Module sent a false signal to the Motor Controller (MC reset error).

A signal problem, not a failed part

An MC reset error is how the manual describes 35: the Motor Controller received a false signal from the Display Module. It is found among the Phase 1 entries, and unlike a code that names a failed part, it does not single one out.

At a glance

Code 35
What it means Phase 1 Smartdrive washers: the Display Module sent a false signal to the Motor Controller (MC reset error).
What you can check There is no reset or front-panel step for this code. Pull the washer's plug before anyone looks behind the console.
When to call a technician A technician should check the cable between the display and controller and, if it is fine, replace the display module. Have the code and model ready.

The pieces involved

Two units share the Smartdrive electronics: a display unit at the panel and a controller that drives the motor. The manual’s name for the cable between them is the 12 way harness, and code 35 describes the exchange over it failing.

  1. First suspect: the 12 way harness connection, where the manual asks for the link between the two units to be checked.
  2. Second suspect: the Display Module, which is replaced only when the harness proves in order.

For the technician

The manual has no reset routine and nothing a user could try at the front panel. Behind the console and inside the machine is where the harness lies. Anyone looking should pull the washer’s plug first, and swapping the Display Module is for whoever holds the correct parts.

Related entries

  • Code 4 and Code 5, listed together, are communication faults of Phase 1, each reported by one end of the link.
  • Code 34 belongs to the brake resistor, on Phase 1.

Fisher & Paykel washer repair in the Miami, New York, Houston, Los Angeles and San Diego metro areas

Call (844) 659-2290 about a Smartdrive washer and have the code and the model number ready.

Source: Fisher & Paykel Smartdrive washer service manual 517766 (March 2003), section 19, Detailed Fault Codes

Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.

Code still active?

Have this Fisher & Paykel alert verified on site

Repeating fault codes usually need platform-specific testing. We confirm the cause and price the fix before work begins.

References

Sources & references

Code still active?

Have this Fisher & Paykel alert verified on site

Repeating fault codes usually need platform-specific testing. We confirm the cause and price the fix before work begins.

Book a repair

Tell us what’s wrong — we’ll take it from there

Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.

Hours Mon–Sat: 8:00 AM – 7:00 PM
Service area Serving Miami, New York, Houston, Los Angeles and San Diego metro areas.
Response time Same-day and next-day appointments in most areas.
Call Book diagnosis