Code 4 comes from the Motor Controller end of a Phase 1 communications fault. A 5-second power cycle is the first line in the manual.
Model compatibility: Fisher & Paykel reuses codes across series and model years, so 4 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
What this code means
On Phase 1 Smartdrive washers, code 4 means the Motor Controller was unable to communicate smoothly with the Display Module.
Think of 4 and 5 as one fault described twice. Code 4 is the version told by the Motor Controller, which was unable to communicate smoothly with the Display Module. Code 5 is how the Display Module words the matching problem from its side. Both sit in the Phase 1 list.
At a glance
| Code | 4 |
|---|---|
| What it means | On Phase 1 Smartdrive washers, code 4 means the Motor Controller was unable to communicate smoothly with the Display Module. |
| What you can check | Switch the washer off at the wall, wait 5 seconds, switch it on again and try once more. This power cycle is the only owner step for code 4. |
| When to call a technician | Call a technician if 4 still shows after the power cycle, since the next steps are module swaps. Mention that you tried the reset. |
Quick reference
| Item | Manual says |
|---|---|
| Phase | 1 only |
| Primary source | Motor Controller |
| Owner-style step | Power off at the wall, power on after 5 seconds, then try again. This is the only one the manual lists for code 4. |
| If the code persists | New Motor Controller, then new Display Module |
| Wiring or moisture checks | None given for code 4 |
Why the swap order matters
Once the Motor Controller has been changed, the display is exchanged as a trial. Should that new display solve the problem, the first Motor Controller returns to service. The sequence is deliberate: it avoids replacing the wrong board, and it can leave a technician reinstalling the part removed at the start.
Codes that sit beside it
- Code 5: the same link seen from the display, with a harness check and a moisture check on top.
- Code 35: a false signal travelling from Display Module to Motor Controller.
- Code 8: the display microprocessor did not start up as it should.
Newer washers
Phases 2 to 6 have their own communication numbers, such as code 104. Code 4 is documented for Phase 1, so it should not be carried over to those machines.
Washer service in the Miami, New York, Houston, Los Angeles and San Diego areas
A Smartdrive washer that still shows 4 after the reset can be reported on (844) 659-2290, which covers the Miami, New York, Houston, Los Angeles and San Diego metro areas. Have the code, the model and a note about the power cycle ready.
Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.
Sources & references
Tell us what’s wrong — we’ll take it from there
Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.