Skip to content
Same-day and next-day appointments in most areas.
Specialized Fisher & Paykel repair service. Experienced technicians, genuine parts, service across major U.S. metro areas.
Error Code

Fisher & Paykel Washer Error 8: Display Micro Would Not Start

Error code 8
Appliance Washer
Quick answer

On Phase 1 washers code 8 means the display processor did not start. A short power-off is the manual's first move.

Model compatibility: Fisher & Paykel reuses codes across series and model years, so 8 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.

Plain language

What this code means

Phase 1 only: the Display micro was unable to start up correctly.

Only Phase 1 washers use code 8. In the manual its heading reads “Phase 1 – Display Module Fault.” The Fisher & Paykel entry reports that the micro, the processor on the display board responsible for the controls, did not manage to start up as it should, and the description goes no further than that.

At a glance

Code 8
What it means Phase 1 only: the Display micro was unable to start up correctly.
What you can check Turn the washer off at the wall, wait around 5 seconds, switch it on and see whether the code appears again. That quick restart is the only owner action.
When to call a technician Call a technician if 8 is still showing after the restart, as the display module then has to be replaced. Say that the five-second power-off did not clear it.

What owners may try

Before parts are replaced, the manual offers a quick restart. Its instruction is to turn off at the wall, turn on again once 5 seconds have passed, and test the washer again. This is the only action addressed to the owner in the entry. If the fault is still there after the restart, the Display module is the part the manual says to replace.

  • Switch the unit off at its wall socket
  • Wait around 5 seconds
  • Switch it on and look for the code
  • Code still showing: replace the Display module

Phase 1 machines

GW500, GW600, GW700, GW050, GW060, GW070 and GW650 make up the manual’s Phase 1 list. Nothing beyond Phase 1 is named for this entry. Phase 1 is the oldest group of washers the manual covers.

Neighbouring Phase 1 entries

Code Summary
5 Trouble with Display-to-Motor Controller communication, plus a power-off step
17 to 20, 22, 23, 28 to 30 Display and Motor Controller falling out of sequence
7 Memory fault in the Display, with no restart suggested

Washer repair for code 8 in our metro areas

For service in the Miami, New York, Houston, Los Angeles and San Diego metro areas, call (844) 659-2290. Give the model number and say that the five-second power-off did not clear 8.

Source: Fisher & Paykel Phase 6 Series 11 (GWL11) supplementary service manual 517766, section 19 Detailed Fault Codes

Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.

Code still active?

Have this Fisher & Paykel alert verified on site

Repeating fault codes usually need platform-specific testing. We confirm the cause and price the fix before work begins.

References

Sources & references

Code still active?

Have this Fisher & Paykel alert verified on site

Repeating fault codes usually need platform-specific testing. We confirm the cause and price the fix before work begins.

Book a repair

Tell us what’s wrong — we’ll take it from there

Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.

Hours Mon–Sat: 8:00 AM – 7:00 PM
Service area Serving Miami, New York, Houston, Los Angeles and San Diego metro areas.
Response time Same-day and next-day appointments in most areas.
Call Book diagnosis