Fisher & Paykel Washer Code 17-30: Display and Motor Controller Out of Sequence
One Phase 1 fault covers nine codes: Display and Motor Controller out of sequence. A 5-second power-off comes first.
Model compatibility: Fisher & Paykel reuses codes across series and model years, so 17 / 18 / 19 / 20 … may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
What this code means
Phase 1: the Display Module and Motor Controller are out of sequence, shared by codes 17-20, 22, 23 and 28-30.
Nine numbers, one fault
Codes 17, 18, 19, 20, 22, 23, 28, 29 and 30 sit together in the Fisher & Paykel service manual as a Phase 1 fault named “Display / Motor Controller out of Sequence”. The manual prints them as three ranges: 17 – 20, 22 – 23 and 28 – 30. The last range carries the instruction “Refer to fault code 17”.
At a glance
| Code | 17 / 18 / 19 / 20 … |
|---|---|
| What it means | Phase 1: the Display Module and Motor Controller are out of sequence, shared by codes 17-20, 22, 23 and 28-30. |
| What you can check | Switch the washer off at the wall socket, wait 5 seconds, switch it on and restart the cycle. These two steps are all an owner can do for these codes. |
| When to call a technician | If the fault remains, a technician is required, as the next test needs a service mode. Note the number shown and whether the power-off made any difference. |
What is out of sequence
The Display Module and the Motor Controller are the two modules that carry the machine through its cycle together. For these codes the manual says they run out of step with one another and supplies no further description.
Remedy as written in the manual
- Switch the washer off at the wall socket.
- After 5 seconds switch on again and restart the cycle.
- Where the fault remains, a technician disables auto restart and tests once more.
- A fresh fault code is displayed; repair proceeds from that code.
An owner can take the first two steps. The third needs a service mode. In the manual’s description, auto restart makes the machine retry a minor fault for as long as eight minutes before a code is shown. It is a service aid meant to stay on in the customer’s home, and it is turned off by a technician only while testing.
Related codes
The manual lists these as separate faults rather than something that follows 17 to 30:
- Code 4 and code 5: Phase 1 communications, Motor Controller to Display Module.
- Codes 81 to 95: Phase 2 and 3 Display to Motor Controller communications.
Fisher & Paykel washer service by phone
Technicians cover the Miami, New York, Houston, Los Angeles and San Diego metro areas; call (844) 659-2290. Quote the number on the display and say if powering off for 5 seconds made any difference.
Source: Fisher & Paykel supplementary service manual 517766, section 19 Detailed Fault Codes
Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.
Sources & references
Tell us what’s wrong — we’ll take it from there
Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.