Code 63 is an internal Motor Controller communications problem on Phase 5; the manual replaces the module.
Model compatibility: Fisher & Paykel reuses codes across series and model years, so 63 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
What this code means
Phase 5: the Motor Controller detected an internal communications problem between its main and pump control systems.
Several other pump entries in the manual blame the pump or its wiring. Code 63 is different: it is the Phase 5 communications error for the pump, and the problem stays inside the Motor Controller module. The module houses both the main control system and the pump control system, which means the entry concerns a single component rather than several linked ones. A technician reading it has one part to look at.
At a glance
| Code | 63 |
|---|---|
| What it means | Phase 5: the Motor Controller detected an internal communications problem between its main and pump control systems. |
| What you can check | Compare the washer label with your model, unplug the washer before anything is opened, and note the code. |
| When to call a technician | Have it serviced, since the controller module itself is the fault and the replacement is for a technician. Keep the model number at hand when you phone. |
Source, action and scope
| Point | Entry |
|---|---|
| Primary source | Motor Controller module |
| Action | Replace the module |
| Machines | Phase 5 |
| Other checks | No pump check, wiring check or reset |
Set beside code 62
Both are Phase 5 pump entries and are easy to confuse. Under 62 too much current reaches the pump, and the pump comes first with the module second. Under 63 the controller struggles to communicate with its pump control system, and the module alone is named.
Models listed for Phase 5
Nine model numbers make up the manual’s Phase 5 table. The GW series gives GW709, GW609 and GW509; then come MW059, LW095 and AW095; the last three are GWC09, GWM09 and GWL09. Intuitive Display (IW) variants are listed beside them. Compare the washer’s label with the table, and unplug the washer before anything is opened.
More Phase 5 codes
- Code 64 covers the water-level sensor signal running below its normal frequency (Phases 5 and 6).
- Code 127 covers a set-up error on the machine that comes from a display that does not match.
Washer service in our metro areas
Confirming the fault is something the manual says should always be done, and a technician can do it. Callers in Miami, New York, Houston, Los Angeles and San Diego can use (844) 659-2290; keep the model number at hand.
Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.
Sources & references
Tell us what’s wrong — we’ll take it from there
Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.