Skip to content
Same-day and next-day appointments in most areas.
Specialized Fisher & Paykel repair service. Experienced technicians, genuine parts, service across major U.S. metro areas.
Error Code

Fisher & Paykel Washer Code 62: Pump Over Current

Error code 62
Appliance Washer
Quick answer

Code 62 flags excess pump current on a Phase 5 washer. The manual names the pump, then the Motor Controller.

Model compatibility: Fisher & Paykel reuses codes across series and model years, so 62 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.

Plain language

What this code means

Phase 5: the Motor Controller detected excessive current in the pump.

62 stands for an over-current alarm at the pump, titled Phase 5 in the service manual. The pump’s current draw is watched by the Motor Controller module, which saw a figure it counts as excessive.

At a glance

Code 62
What it means Phase 5: the Motor Controller detected excessive current in the pump.
What you can check Nothing here is an owner job, and no symptoms are given to check from outside. Pull the plug and keep out of the pump area while there is water in the tub.
When to call a technician Leave this to a technician, as the pump or the controller module needs replacing. The pump holds water and the module is live electronics, so do not open anything yourself.

Two parts, ranked

Rank Source Manual’s action
1 Pump Replace the pump
2 Motor Controller module Replace the module

The manual lists the pump first, so it is the more likely culprit, and the module is the fallback when the pump is not the cause.

Detector and suspect

The module that detects the pump current is the Motor Controller, so here the same part reports the fault and ranks second among the suspects.

Outward signs

Symptoms are not listed, so there is nothing to verify from outside the washer. For this code the manual mentions no blockage, although pump blockage appears under other fault numbers. Where 37 or 44 also show, they concern draining and make useful companion reading.

Safety

Water runs through the pump, and the module is live electronics. Pull the plug, keep out of the pump area with water in the tub, and hand replacement to a technician.

Codes around the pump

  • Code 37 is no change in water level while draining.
  • Code 63 is a communication problem between the controller and the pump control system.
  • Code 44 is water left in the tub during spin.

Pump service in the metro areas we cover

A Phase 5 washer with code 62 around Miami, New York, Houston, Los Angeles or San Diego can be reported on (844) 659-2290. Give the model number.

Source: Fisher & Paykel Phase 6 Series 11 (GWL11) supplementary service manual 517766, section 19 Detailed Fault Codes

Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.

Code still active?

Have this Fisher & Paykel alert verified on site

Repeating fault codes usually need platform-specific testing. We confirm the cause and price the fix before work begins.

References

Sources & references

Code still active?

Have this Fisher & Paykel alert verified on site

Repeating fault codes usually need platform-specific testing. We confirm the cause and price the fix before work begins.

Book a repair

Tell us what’s wrong — we’ll take it from there

Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.

Hours Mon–Sat: 8:00 AM – 7:00 PM
Service area Serving Miami, New York, Houston, Los Angeles and San Diego metro areas.
Response time Same-day and next-day appointments in most areas.
Call Book diagnosis