Fisher & Paykel Refrigerator Code 1: Power Module Self-Test Failed
The power module failed its self-test during the last power-up, so the display shows code 1. Service replaces the module.
Model compatibility: Fisher & Paykel reuses codes across series and model years, so 1 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
What this code means
On the last power up, the power module failed its self-test.
Each time an Active Smart refrigerator from Fisher & Paykel is switched on at the supply, its power module checks itself. Code 1 is recorded if that check was failed at the last switch-on. This concerns the electronics, and has nothing to do with temperature or airflow.
At a glance
| Code | 1 |
|---|---|
| What it means | On the last power up, the power module failed its self-test. |
| What you can check | There is no owner repair for this code. Press any control button to mute the alarm. Switching off and on at the supply only reruns the self-test, which shows whether the fault persists. |
| When to call a technician | Book a service visit if code 1 reappears after a power reset, since the power module needs replacing. Otherwise the alarm clears on its own after 72 hours. Keep the doors shut where you can. |
Why the board matters
Fans, low ambient heater and temperature sensors are all fed by the power module, which also collects their readings. A module that fails its own check puts every one of those readings in doubt. For that reason the manual calls this a board problem.
How the fault is signalled
- The display shows the code by itself, accompanied by a sound alarm.
- The lowest LED blinks red, taking turns with the pattern that spells out the code.
- A press on any control button mutes the alarm. For 8 seconds the display looks normal, then the code is back.
Across the LEDs the code is binary, and 1 is the smallest value, a lone LED counting as 1.
What the manual lists
Replace the power module. That is the only action given, and no owner-level check comes with it. Switching off and on at the supply merely reruns the self-test, showing if the fault persists. If the noise is the nuisance, unplugging the cabinet for a few seconds also resets the alarm; otherwise it clears on its own after 72 hours.
Leave the doors shut where you can until it has been looked at.
More codes to read next
- Code 11: the heater and fans together are drawing too little, and the repair there can finish at the module too.
- Code 3: every temperature sensor out of range, with the same module as the final step.
Fisher & Paykel refrigerator service across Miami, New York, Houston, Los Angeles and San Diego
Service for these refrigerators covers the Miami, New York, Houston, Los Angeles and San Diego metro areas. Call (844) 659-2290 if code 1 reappears after a power reset, and have the model number and exact code ready. The refrigerator repair page has the details.
Source: Fisher & Paykel Active Smart Refrigerators USA service manual 517775
Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.
Sources & references
Tell us what’s wrong — we’ll take it from there
Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.