Fisher & Paykel Washer Code 162: Brake Deceleration Time-out
Fault 162 flags a basket that failed to stop in time during braking. The manual gives no cause or action and calls it a software test code.
Model compatibility: Fisher & Paykel reuses codes across series and model years, so 162 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
What this code means
Brake deceleration time-out below 100 rpm; the manual states the fault was installed for software testing only.
In the manual, 162 is “Brake Deceleration Time-out Fault” and applies on Phases 3 to 5. Its entry is brief.
At a glance
| Code | 162 |
|---|---|
| What it means | A brake deceleration time-out below 100 rpm, a code installed for software testing only. |
| What you can check | Record it as shown, with what the washer was doing, such as a spin finishing, and switch off at the wall before anyone looks inside. |
| When to call a technician | Have a technician look at the washer if the code shows, because no cause or action is given for it. Provide the model number and anything that happened before the display changed. |
Definition
- Brake mode is active, and the Motor Controller observes the basket losing speed.
- Below 100 rpm, the basket has a set period to come to a stop.
- Failure to stop in that period gets 162 flagged.
According to the manual, the fault “has been installed for software testing only.” No primary or secondary source appears, and no action either.
Owner position
No reset sequence or checklist for 162 exists in the source. When the code appears, record it as shown and add the washer’s activity at that moment, such as a spin finishing. The power should be off at the wall before anyone looks inside.
Other braking and motor codes
A braking problem that does come with a written procedure is 164: braking has lasted 20 seconds, and the motor wiring is the manual’s first stop. 34 is the brake resistor fault, for Phase 1 only, while 136 is a motor stall.
What cannot be said
Neither a cause nor an action is listed for 162, so it cannot be said whether it points to a part.
Washer service across the metro areas
Fisher & Paykel washer service calls for the Miami, New York, Houston, Los Angeles and San Diego metro areas are taken on (844) 659-2290. Provide the model number and code, and anything that happened before the display changed.
Source: Fisher & Paykel supplementary service manual 517766, section 19 Detailed Fault Codes
Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.
Sources & references
Tell us what’s wrong — we’ll take it from there
Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.