Fisher & Paykel Washer Code 48: Hot and Cold Valve Fault
Code 48 sets out the valve fault procedure: both hot and cold valves flagged, with wiring checked before coils and the controller.
Model compatibility: Fisher & Paykel reuses codes across series and model years, so 48 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
What this code means
Voltages from the valve diagnostic circuit show both hot and cold valves as faulty, most likely through wiring or an open circuit coil.
What 48 reports
The manual writes its procedure for the three valve codes under 48. Here the Motor Controller holds voltages from the valve diagnostic circuit that mark both hot and cold valves as faulty. The reasons judged most probable are a valve harness not hooked up correctly, or a valve that has gone open circuit. It covers Phases 2 to 6.
At a glance
| Code | 48 |
|---|---|
| What it means | Voltages from the valve diagnostic circuit show both hot and cold valves as faulty, most likely through wiring or an open circuit coil. |
| What you can check | Valves and wiring can only be reached by opening the machine, so keep to what can be seen: the code and the washer's model. |
| When to call a technician | Name which of codes 48, 49 or 50 appeared when you ring a technician. Checking the valve harness and coils needs the machine opened. |
Suspects
| Rank | Part | Check |
|---|---|---|
| Primary | Wiring | Harnesses fastened to the valves properly; no pins bent backwards |
| Secondary | Water valves | Coils in good order, meaning not open circuit |
| Tertiary | Motor Controller module | Replace |
Series 11 background
On the Series 11 washer, the valves are rated 24 volt, and their resistance is 64 ohms at 20 C (68 F). When fitting a new valve, use the same or a superseding part number, since threads vary between models and an unsuitable one can leak at the inlet hoses. RAST 2.5 is the terminal system, and the connectors must go on squarely.
How far an owner goes
The manual looks at wiring first, before the coils, and the valves can only be reached by opening the machine. Keep to what can be seen: the code, and the model.
Codes splitting the same fault
Code 49 deals with the cold (proportional) valve on its own, code 50 with the hot (digital) valve on its own, and code 33 is the water valve fault for Phase 1.
Valve service across the metro areas
Phone (844) 659-2290 for service in Miami, New York, Houston, Los Angeles or San Diego, and name which of 48, 49 or 50 appeared.
Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.
Sources & references
Tell us what’s wrong — we’ll take it from there
Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.