Fisher & Paykel Refrigerator Code 4: Low Resistance on All Sensors
A 4 on the display means every temperature sensor is reading under 660 ohms together.
Model compatibility: Fisher & Paykel reuses codes across series and model years, so 4 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
What this code means
Resistance on all of the temperature sensors is below the normal range, under 660 ohms.
What the 4 is reporting
A flashing 4 on an Active Smart refrigerator widens the problem beyond one sensor: all of them returned under 660 ohms together. The manual deals with it just as it deals with code 3, where the readings are too high.
At a glance
| Code | 4 |
|---|---|
| What it means | Resistance on all of the temperature sensors is below the normal range, under 660 ohms. |
| What you can check | Hush the alarm with a button. Keep checking the temperature of your food, because misread sensors can leave the refrigerator running either too warm or too cold. Do not touch the connectors. |
| When to call a technician | Expect a technician to check and remake the connector at the power module, and replace the module if that does not clear the code. Book a service visit. |
Why the readings are low
Each sensor is a thermistor whose resistance falls when it warms. At 50 degrees C, the warmest point in the manual’s table, the figure is still 0.9106 kilohms, higher than 660 ohms. So a reading below that is hotter than the table covers, or a short across the sensor wires. All sensors failing at once is why the manual looks at the shared connector and board ahead of any single sensor.
Fault-finding sequence
- Primary action: check the 6-way RAST connector at the power module.
- Secondary action: reterminate the 6-way RAST connector.
- Tertiary action: replace the power module.
Three sensors, one family
The manual names a PC sensor for fresh food, an FC sensor for the freezer, and the evaporator (defrost) sensor. In diagnostic mode a technician reads each one: hold MODE, press temperature UP, read the LEDs as a binary pattern, add the lit values and subtract 40 for degrees C. MODE exits it; otherwise it ends by itself after 5 minutes.
Advice for the household
Connectors are not for owners to touch. The alarm can be quieted by a button. Keep checking the temperature of food, because misread sensors can leave the refrigerator running either too warm or too cold.
Also see
Fisher & Paykel refrigerator service in Miami, New York, Houston, Los Angeles and San Diego
Our team covers the Miami, New York, Houston, Los Angeles and San Diego metro areas. Phone (844) 659-2290 with the code, the model number and what you have already tried. The refrigerator repair page explains the rest.
Source: Fisher & Paykel Active Smart Refrigerators USA service manual 517775
Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.
Sources & references
Tell us what’s wrong — we’ll take it from there
Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.